WB-8112B dual channel vibration monitor is an ideal instrument for vibration measurement of rotating machinery, which is used together with eddy current sensor.

WB-8112B dual channel vibration monitor can be widely used in power generation, petroleum, chemical industry, metallurgy and other sectors of rotating machinery shaft vibration measurement and protection control.

Application Introduction:

Fault monitoring:

It can monitor the radial vibration of the rotor of the rotating machinery, measure the vibration and swing of the shaft, and monitor the excessive vibration caused by the imbalance, misalignment and looseness of the rotor.

Measurement parameters:

Radial vibration and amplitude of rotor.

Unit type:

Monitoring of various rotating machines. Such as steam turbine, fan, compressor, motor, pump, etc.

Installation requirements:

For units with existing eddy current probe system, it is only necessary to connect the wires and set alarm and danger points.

Main performance indexes:

Power supply: 220VAC

Input impedance: 10K Ω

Frequency response: 0 ~ 10kHz

Display mode: three and a half LED digital display

Accuracy: indication error ≤ 1%; standard output ≤ 1%

Output signal: Voltage 1 ~ 5V, output load ≥ 1K Ω;

Current 4 ~ 20mA, output load ≤ 500 Ω

Alarm shutdown: two levels, setting range is 5% ~ 100% of the range

Relay contact capacity: 28VDC, 5A or 115VAC, 0.5A

Boundary dimension: 270 (L) × 160 (W) × 80 (H) (unit: mm)

Installation dimension: (150 + 1) (width) × (74 + 1) (width) (unit: mm)

Weight: 2kg

Operating environment: temperature: - 10 ~ 50 ℃; humidity: ＜ 80%

Storage temperature: - 20 ~ 75 ℃