TR shaft vibration transmitter, which integrates the functions of proximitor, peak to peak detection, voltage and current normalization, provides a simple and low-cost way to monitor the radial vibration of rotating machinery rotor directly with DCS and PLC interface.

The TR shaft vibration transmitter converts the vibration signal sensed by the probe into the standard current signal output after the detection normalization, and the current value is proportional to the vibration peak value.

Application Introduction:

Fault monitoring:

It can monitor the radial vibration of the rotor of rotating machinery, and measure the vibration and swing of the shaft.

Measurement parameters:

Monitor excessive vibration caused by rotor imbalance, misalignment, loose parts, etc.

Unit type:

Vibration monitoring of various rotating machines. Such as steam turbine, fan, compressor, motor, pump, etc.

Use requirements:

It is connected with eddy current probe and extension cable, and the installation position is the safe position of the unit on site.

Main performance indexes:

Power supply: +24VDC

Full scale output:  4~20mA

Measurement error:  ≤1%FS

Environmental indicators:  temperature -20~60℃; humidity ＜80%